GE 752 Series Wound
1 each, “A” and 1 each “B” motor, re-manufactured GE752 motor equipped as follows:
1000HP/750 VDC/1050 amps
New drilling frame
Land rig motor
Single shaft (NON ABS)
VPI’d coils and armature
New oilfield Hub
New 535 (NON armored) cables customer preferred side lead exit
New mild steel j box, terminal board, XP pressure and lockout switch, for BOLT ON Connections,
customer preferred side.20 pin connector installed.
New 230 volt NON XP strip heater, 500 watts.
New bearings, T900 brushes, gaskets.
New inspection covers and exhausts per design.
Standard comutator per original design.
No load tested
National Blue paint.
2 each 10 HP patented, Gulf Electroquip, Double Clean blowers, 460 volts, 3 phase, 60 hertz, 3600
National Blue paint. Blowers to fit above GE752 remanufactured motors.
Full load test (4 hour)
Stainless steel junction box
Spark Arrestors (mild steel) for mud pump
RTD’s installed in windings (100 ohm platinum)